Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R730 Owner's Manual

PDF

Replacing the system battery

Prerequisites

NOTE: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your system.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.

Steps

  1. Locate the battery socket. For more information, see the Jumpers and connectors section.
    CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
  2. Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the socket.
    Figure 1. Removing the system battery
    This figure shows removing the system battery.
    1. system battery
    2. system battery slot
  3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
  4. Press the battery into the connector until it snaps into place.
    Figure 2. Installing the system battery
    This figure shows installing the system battery.
    1. system battery
    2. system battery slot

Next steps

  1. Install the cooling shroud.
  2. Follow the procedure listed in the After working inside your system section.
  3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
  4. Enter the correct time and date in the System Setup Time and Date fields.
  5. Exit System Setup.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"