Dell PowerEdge R730 Owner's Manual

Options to set up iDRAC IP address

You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC. You can set up the IP address by using one of the following interfaces:

Interfaces: Document/Section
iDRAC Settings utility: See iDRAC User's Guide available at https://www.dell.com/idracmanuals
Dell Deployment Toolkit: See OpenManage Deployment Toolkit User's Guide available at https://www.dell.com/openmanagemanuals
Dell Lifecycle Controller: See Lifecycle Controller User's Guide available at https://www.dell.com/idracmanuals
Chassis or Server LCD panel: See the LCD panel section

You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for iDRAC.

NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet connector 1 on the system board.

NOTE: Ensure that you change the default user name and password after setting up the iDRAC IP address.

Bienvenido

Bienvenido a Dell

Dell PowerEdge R730 Owner's Manual

Options to set up iDRAC IP address

Califique este contenido