Dell Chassis Management Controller Version 1.3 for PowerEdge FX2/FX2s RACADM Command Line Reference Guide

testtrap

Description	Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to a specified destination trap listener on the network. To use this subcommand, you must have the Test Alerts permission. NOTE: Before you execute the `testtrap` subcommand, make sure that the specified index in the RACADM cfgAlerting group is configured properly.
Synopsis	racadm testtrap -i < index>
Input	-i — Specifies the index of the trap configuration to be used for the test. Valid values are from 1 to 4.
Example	Commands for the cfgIpmiPet group: Enable the alert racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1 Set the destination e-mail IP address racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr -i 1 192.168.0.110 View the current test trap settings racadm getconfig -g cfgIpmiPet -i < index> where < index> is a number from 1 to 4.