- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the hard drive
- Replacing the hard drive
- Removing the wireless card
- Replacing the wireless card
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the memory modules
- Replacing the memory modules
- Removing the rear-I/O cover
- Replacing the rear-I/O cover
- Removing the computer base
- Replacing the computer base
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the speakers
- Replacing the speakers
- Removing the I/O board
- Replacing the I/O board
- Removing the subwoofer
- Replacing the subwoofer
- Removing the system-board assembly
- Replacing the system board
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the power-button board
- Replacing the power-button board
- Removing the display assembly
- Replacing the display assembly
- Removing the battery
- Replacing the battery
- Removing the touchpad
- Replacing the touchpad
- Removing the keyboard
- Replacing the keyboard
- Removing the palm rest
- Replacing the palm rest
- Removing the display bezel
- Replacing the display bezel
- Removing the tobii eye-tracker module
- Replacing the tobii eye-tracker module
- Removing the logo board
- Replacing the logo board
- Removing the display panel
- Replacing the display panel
- Removing the camera
- Replacing the camera
- Removing the display hinges
- Replacing the display hinges
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- BIOS overview
- Diagnostics
- Getting help and contacting Alienware
Alienware 17 R4 Service Manual
Procedure
- Remove the two screws (M2x3) that secure the logo board to the display back-cover and antenna assembly.
- Turn the logo board over.
- Disconnect the tron-light cable from the logo board.
- Pull the latch that secures the Alienhead cable to the logo board.
- Disconnect the Alienhead cable from the logo board.
- Disconnect the logo-board cable from the logo board.
- Disconnect the tron-light cable from the logo board.
- Lift the logo board off the display back-cover
and antenna assembly.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\