Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

iDRAC 8/7 v2.30.30.30 User’s Guide

PDF

Updating device firmware using HTTP

You can directly connect to the HTTP site from iDRAC to perform the firmware updates. You can use the Windows-based update packages (DUPs) and a catalog file available on the HTTP site instead of creating custom repositories.
Before performing an update using the repository, make sure that:
  • Lifecycle Controller is enabled.
  • You have Server Control privilege to update firmware for devices other than iDRAC.

To update device firmware using HTTP:

  1. In the iDRAC web interface, go to Overview > iDRAC Settings > Update and Rollback . The Firmware Update page is displayed.
  2. On the Update tab, select HTTP as the File Location.
  3. In the HTTP Server Settings section, enter the HTTP details. For information about the fields, see the iDRAC Online Help.
  4. Click Check for Update.
  5. After the upload is complete, the Update Details section displays a comparison report showing the current firmware versions and the firmware versions available in the repository.
    • NOTE: Any update in the repository that is not applicable to the system or the installed hardware or is not supported is not included in the comparison report.
  6. Select the required updates and do one of the following:
    • For firmware images that do not require a host system reboot, click Install. For example, .d7 firmware file.
    • For firmware images that require a host system reboot, click Install and Reboot or Install Next Reboot.
    • To cancel the firmware update, click Cancel.

    When you click Install, Install and Reboot or Install Next Reboot, the message Updating Job Queue is displayed.

  7. Click Job Queue to display the Job Queue page, where you can view and manage the staged firmware updates or click OK to refresh the current page and view the status of the firmware update.
Enter the tasks the user should do after finishing this task (optional).

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \