Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

Dell PowerEdge M830 (For Dell PowerEdge VRTX Enclosure) Owner's Manual

PDF

Installing the IDSDM card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #2 Phillips screwdriver ready.

  4. Remove the IDSDM card.
    CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.
    NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the system.

Steps

  1. Align the following:
    • The slot on the card edge with the projection tabs on the PCIe mezzanine card support.
    • The two screw holes on the IDSDM card with the standoffs on the system board.
    • The hole on the SD card slot bracket with the screw hole on the IDSDM card.
  2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
    Figure 1. Installing the IDSDM card
    The image shows installing the IDSDM card.
    1. IDSDM card
    2. screw (2)
    3. SD card slot bracket
    4. PCIe mezzanine card support bracket
    5. connector
    6. standoff (2)

Next steps

  1. If applicable, install the SD card(s) and the internal USB key.

  2. Install the PCIe mezzanine card.

  3. Follow the procedure listed in the After working inside your system section.

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \