Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

Dell PowerEdge M830 (For Dell PowerEdge VRTX Enclosure) Owner's Manual

PDF

Installing the storage controller card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #2 Phillips screwdriver ready.

  4. Remove the storage controller card.
    NOTE: You must remove the storage controller card to replace a faulty storage controller card or service other components inside the system.

Steps

  1. Align the slots on the storage controller card edge with the tabs on the support bracket.
    CAUTION: To prevent damage to the storage controller card, hold the card only by its edges.
  2. Lower the storage controller card on to the connector on the system board.
  3. Tighten the two retention screws on the hard-drive backplane or SSD backplane cable connector to secure the card on to the system board.
    Figure 1. Installing the storage controller card
    This figure shows installing the storage controller card.
    1. retention screw (2)
    2. slot on the PCIe extender or storage controller card
    3. tab on the PCIe extender or storage controller card support bracket
    4. standoff (2)

Next steps

  1. Install the following:

    1. hard drives or SSDs

    2. hard-drive backplane or SSD backplane

    3. hard-drive cage or SSD cage

  2. Follow the procedure listed in the After working inside your system section.

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \