- Notes, cautions, and warnings
- Dell Chassis Management Controller for Dell EMC PowerEdge VRTX
- Platforms Affected
- License Requirements
- What is Supported
- What is new
- Fixes
- Important Notes
- Known Issues
- Flex address disabled after racresetcfg of CMC
- RAID-related operations might take longer to report status
- Error occurs while importing CMC configuration file
- Chassis overview health tab does not display alert
- Server components update page gets corrupt
- Controller failover feature does not work
- Active alert for degraded virtual disk is not displayed
- SPERC information is displayed partially on LCD display
- Unable to view chassis logs from remote RACADM
- Static IPv6 IP address can be assigned to iDRAC blades
- Limitations
- PSOC Read Me
- Installation
- Accessing documents from Dell Support site
- Contacting Dell EMC
Dell Chassis Management Controller Version 3.20 for PowerEdge VRTX Release Notes
Error occurs while importing CMC configuration file
- Description
- An error occurs while importing CMC configuration file using local or remote RACADM.
- Resolution
- This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6 using the command, racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0.
- Versions/Systems affected
- CMC Version 2.0 or later for Dell PowerEdge VRTX
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\