- Notes, cautions, and warnings
- Dell Chassis Management Controller for Dell EMC PowerEdge VRTX
- Platforms Affected
- License Requirements
- What is Supported
- What is new
- Fixes
- Important Notes
- Known Issues
- Flex address disabled after racresetcfg of CMC
- RAID-related operations might take longer to report status
- Error occurs while importing CMC configuration file
- Chassis overview health tab does not display alert
- Server components update page gets corrupt
- Controller failover feature does not work
- Active alert for degraded virtual disk is not displayed
- SPERC information is displayed partially on LCD display
- Unable to view chassis logs from remote RACADM
- Static IPv6 IP address can be assigned to iDRAC blades
- Limitations
- PSOC Read Me
- Installation
- Accessing documents from Dell Support site
- Contacting Dell EMC
Dell Chassis Management Controller Version 3.20 for PowerEdge VRTX Release Notes
Installation Procedure
- In the CMC web interface, click Chassis Overview, and then click Update.
- On the Firmware Update page, in the CMC Firmware section, select the required components under the Update Targets column for the CMC or CMCs (if a standby CMC is present) you want to update, and then click Apply CMC Update.
- In the Firmware Image box, type the path to the firmware image file on the management station or shared network, or click Browse to browse through to the file location. The default name of the CMC firmware image file is vrtx_cmc.bin.
- Click Begin Firmware Update, and then click Yes. The Firmware Update Progress section displays information about the firmware update status.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\