메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
  • 회사 관리를 사용하여 Dell EMC 사이트, 제품 및 제품 수준 연락처를 관리하십시오.
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R730 Owner's Manual

PDF

Installing a hot swappable hard drive or solid state drive

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: Use only hard drives that have been tested and approved for use with the hard drive backplane.
CAUTION: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard drive carrier and attempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield spring and make it unusable.
CAUTION: Combining SAS and SATA hard drives in the same RAID volume is not supported.
CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the documentation supplied with your operating system.
CAUTION: When a replacement hot swappable drive is installed and the system is powered on, the drive automatically begins to rebuild. Ensure that the replacement drive is blank or contains data that you wish to overwrite. Any data on the replacement drive is immediately lost after the drive is installed.

Steps

  1. If a hard drive blank is installed in the hard drive slot, remove it.
  2. Install a hard drive in the hard drive carrier.
  3. Press the release button on the front of the hard drive carrier and open the hard drive carrier handle.
  4. Insert the hard drive carrier into the hard drive slot until the carrier connects with the backplane.
  5. Close the hard drive carrier handle to lock the hard drive in place.
    Figure 1. Installing a hot-swappable hard drive or SSD
    This figure shows installing a hot-swappable hard drive or SSD.
    1. release button
    2. hard drive or SSD carrier
    3. hard drive or SSD carrier handle
    Figure 2. Installing a 1.8 inch hot-swappable uSATA SSD carrier
    This figure shows installing a 1.8 inch hot-swappable uSATA SSD carrier.
    1. release button
    2. SSD carrier
    3. SSD carrier handle

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.