Dell PowerEdge R730 Owner's Manual

Removing the integrated storage controller card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.
Remove the cooling shroud.
Remove the expansion card riser 1.
Keep the Phillips #2 screwdriver ready.

Steps

Loosen the screws that secure the integrated storage controller cable to the integrated storage controller card connector on the system board.
Lift the integrated storage controller cable away from the integrated storage controller.
Lift one end of the card and angle it to disengage the card from the integrated storage controller card holder on the system board.
Lift the card out of the system.
Figure 1. Removing the integrated storage controller card
1. integrated storage controller cable
2. integrated storage controller card
3. integrated storage controller card connector on the system board
4. integrated storage controller card holder

Next steps

Install the expansion card riser 1.
Install the cooling shroud.
Installing the integrated storage controller card.
Follow the procedure listed in the After working inside your system section.

환영

환영합니다.

Dell PowerEdge R730 Owner's Manual

Removing the integrated storage controller card

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.