Dell PowerEdge R730 Owner's Manual

Installing an expansion card into the expansion card riser 2 or 3

Prerequisites

Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
Lift the expansion card latch and remove the filler bracket.
Holding the card by its edges, position the card so that the connector on the expansion card aligns with the expansion card connector on the riser.
Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
Press the touch points to open the expansion card locking tabs.
Close the expansion card latch.
Figure 1. Installing an expansion card into the expansion card riser 2 or 3
1. expansion card
2. expansion card latch
3. expansion card riser
4. power connector (for GPU cards)
5. expansion card connector
If applicable, connect the cables to the expansion card.
NOTE: When installing a GPU card on riser 2 or riser 3 (default), connect the GPU card power cable to the power connector on the riser.

Next steps

Follow the procedure listed in the After working inside your system section.
Install any device drivers required for the card as described in the documentation for the card.

환영

환영합니다.

Dell PowerEdge R730 Owner's Manual

Installing an expansion card into the expansion card riser 2 or 3

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.