- Notes, cautions, and warnings
- About this document
- PowerEdge XR11 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- Bezel filter
- System cover
- Air shrouds
- Cooling fans
- Intrusion switch module
- Drives
- Drive backplane
- Internal storage configuration matrix for XR11
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Optional BOSS S1 card
- System battery
- Internal USB memory key
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Removing the status LED control panel for Rear Accessed configuration
- Installing the status LED control panel for Rear Accessed configuration
- Removing the power button control panel for Rear Accessed configuration
- Installing the power button control panel for Rear Accessed configuration
- Removing the status LED control panel for Front Accessed configuration
- Installing the status LED control panel for Front Accessed configuration
- Removing the power button control panel for Front Accessed configuration
- Installing the power button control panel for Front Accessed configuration
- MIL 901E and MIL 461G rugged kit
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge XR11 Installation and Service Manual
About this document
This document provides an overview about the system, information about installing and replacing components, diagnostic tools, and guidelines to be followed while installing certain components.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\