Dell PowerEdge C4130 Owner's Manual

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in before working inside your system.
3. Keep the Phillips #2 screwdriver ready.

1. If applicable, install the Trusted Platform Module (TPM).
2. Replace the following components:
   1. Internal USB key, if applicable
   2. Internal dual SD module
   3. Expansion card riser
   4. PSU(s)
   5. 2.5 inch hard drive cage, if applicable
   6. Processors(s)/processor blank(s)
   7. Heat sink(s)
   8. PCIe shroud
   9. Memory modules and memory module blanks
   10. 1.8 inch SSD cage with the backplane
   11. Cooling shroud
   12. Cable routing clip
3. Reconnect all cables to the system board.

   NOTE: Ensure that the cables inside the system are routed along the chassis wall and the GPU and hard drive cables are routed through the cable routing clip.

4. Follow the procedure listed in after working inside your system.
5. Ensure that you perform the following steps:
   1. Use the Easy Restore feature to restore the service tag.
   2. If the service tag is not backed up in the backup flash device, enter the system service tag manually.
   3. Update the BIOS and iDRAC versions.
   4. Re-enable the Trusted Platform Module (TPM).