Avançar para o conteúdo principal
  • Efetuar encomendas de forma rápida e fácil
  • Ver todas as encomendas e controlar o seu estado de expedição
  • Criar e aceder a uma lista dos seus produtos
  • Gerencie seus sites, produtos e contatos de nível de produto da Dell EMC usando o Company Administration.

Dell PowerEdge C4130 Owner's Manual

Removing a GPU riser cable board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Philips #2 screwdriver ready.
  3. Remove the GPU from the chassis.
  4. Disconnect the power cables connected to the GPU.

Steps

  1. Remove the screws securing the GPU riser cable board to the GPU.
  2. Pull the GPU riser cable board to disengage the connector on the GPU riser cable board from the GPU.
  3. Remove the GPU riser cable routed through the GPU riser cable clip.
    Figure 1. Removing a GPU riser cable board
    This figure shows removing of a GPU riser cable board.
    1. connector on the GPU riser cable board
    2. GPU riser cable board
    3. GPU riser cable
    4. screw (3)
    5. GPU riser cable clip
    6. GPU

Next steps

Removing the custom GPU brackets from the GPUs removed from your system.


Classifique este conteúdo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
0/3000 characters
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Selecione se o artigo foi útil ou não.
  Os comentários não podem conter estes caracteres especiais: <>()\