- Notes, Cautions, and Warnings
- About Your System
- Using The System Setup And Boot Manager
- Installing System
Components
- Recommended Tools
- Front Bezel (Optional)
- Opening And Closing The System
- Inside The System
- Cooling Shroud
- System Memory
- Hard Drives
- Removing A 2.5 Inch Hard-Drive Blank
- Installing A 2.5 Inch Hard-Drive Blank
- Removing A 3.5 Inch Hard-Drive Blank
- Installing A 3.5 Inch Hard-Drive Blank
- Removing A Hot-Swap Hard Drive
- Installing A Hot-Swap Hard Drive
- Removing A Cabled Hard Drive
- Installing A Cabled Hard Drive
- Removing A 2.5 Inch Hard Drive From A 3.5 Inch Hard-Drive Adapter
- Installing A 2.5 Inch Hard Drive Into A 3.5 Inch Hard-Drive Adapter
- Removing A Hard Drive Or A Hard-Drive Adapter From A Hard-Drive Carrier
- Installing A Hard Drive Or A Hard-Drive Adapter Into A Hard-Drive Carrier
- Optical Drive (Optional)
- Cooling Fans
- Internal USB Memory Key (Optional)
- Expansion Cards And Expansion-Card Risers
- iDRAC Ports Card (Optional)
- SD vFlash Card
- Internal Dual SD Module
- Internal SD Card
- Integrated Storage Controller Card
- Processor
- Power Supplies
- System Battery
- Hard-Drive Backplane
- Control Panel Assembly
- VGA Module
- Power Distribution Board Shroud
- Power Distribution Board
- System Board
- Troubleshooting
Your System
- Troubleshooting System Startup Failure
- Troubleshooting External Connections
- Troubleshooting The Video Subsystem
- Troubleshooting A USB Device
- Troubleshooting A Serial I/O Device
- Troubleshooting A NIC
- Troubleshooting A Wet System
- Troubleshooting A Damaged System
- Troubleshooting The System Battery
- Troubleshooting Power Supplies
- Troubleshooting Cooling Problems
- Troubleshooting Cooling Fans
- Troubleshooting System Memory
- Troubleshooting An Internal USB Key
- Troubleshooting An SD Card
- Troubleshooting An Optical Drive
- Troubleshooting A Tape Backup Unit
- Troubleshooting A Hard Drive
- Troubleshooting A Storage Controller
- Troubleshooting Expansion Cards
- Troubleshooting Processors
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Dell PowerEdge R320 Systems Owner's Manual
NIC Indicator Codes
- Indicator
- Indicator Code
- Link and activity indicators are off
- The NIC is not connected to the network.
- Link indicator is green
- The NIC is connected to a valid network at its maximum port speed (1 Gbps or 10 Gbps).
- Link indicator is amber
- The NIC is connected to a valid network at less than its maximum port speed.
- Activity indicator is blinking green
- Network data is being sent or received.
Поставьте оценку (1–5 звезд).
Поставьте оценку (1–5 звезд).
Поставьте оценку (1–5 звезд).
Выберите ответ на вопрос, была ли статья полезной.
Комментарии не должны содержать следующие специальные символы: <>()\