Dell PowerEdge R320 Systems Owner's Manual

Troubleshooting A Tape Backup Unit

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Try using a different tape cartridge.
Ensure that the device drivers for the tape backup unit are installed and are configured correctly. See your tape drive documentation for more information about device drivers.
Reinstall the tape-backup software as instructed in the tape-backup software documentation.
Ensure that the tape drive’s interface cable is fully connected to the external port on the controller card.
Check that the controller card is properly installed:
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system.
3. Reseat the controller card in the expansion card slot.
4. Close the system.
5. Turn on the system and attached peripherals.
Run the appropriate diagnostic test. For more information, see Using System Diagnostics.

If you cannot resolve the problem, see Getting Help.