The system health and system ID indicator is located on the left control panel of your system.
Table 1. System health
and system ID indicator codesThis table describes the system health and system
ID indicators. Item 1 indicates Solid blue where the condition indicates that the system is turned on, system
is healthy, and system ID mode is not active. Press the system health
and system ID button to switch to system ID mode. Item 2 indicates Blinking blue where the condition indicates that the system ID mode is
active. Press the system health and system ID button to switch to
system health mode. Item 3 indicates solid amber where the condition indicates that the system is in fail-safe
mode. If the problem persists, see the Getting help section. Item 4 indicates blinking amber where the condition indicates that the system is experiencing
a fault. Check the System Event Log or the LCD panel, if available
on the bezel, for specific error message. For information about the event and error messages generated by the system firmware and agents that monitor system components, see the Error Code Lookup page at
qrl.dell.com.
System health and system ID indicator
code
Condition
Solid blue
Indicates that the system is turned on, system
is healthy, and system ID mode is not active. Press the system health
and system ID button to switch to system ID mode.
Blinking blue
Indicates that the system ID mode is
active. Press the system health and system ID button to switch to
system health mode.
Solid amber
Indicates that the system is in fail-safe
mode. If the problem persists, see the Getting help section.
Blinking amber
Indicates that the system is experiencing
a fault. Check the System Event Log or the LCD panel, if available
on the bezel, for specific error message. For information about the event and error messages generated by the system firmware and agents that monitor system components, see the Error Code Lookup page at
qrl.dell.com.