Dell EMC PowerEdge R7415 Installation and Service Manual

Installing the expansion card risers

Follow the safety guidelines listed in Safety instructions.

If removed, install the expansion cards into the expansion card risers.
Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Figure 1. Installing the riser 3A
1. For the riser 1A, tighten the captive screw to secure the riser to the system board.
  Figure 2. Installing the riser 1A
2. For the riser 1B, tighten the captive screws and replace the screw at the back of the riser to firmly hold the riser to the system board.
  Figure 3. Installing the riser 1B

Install the air shroud.
If removed, install the rear drive cage.
Install any device drivers required for the card as described in the documentation for the card.
Follow the procedure listed in After working inside your system.