- Notes, cautions, and warnings
- Dell EMC PowerEdge R7415 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System BIOS
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- NVMe Settings
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Choosing system boot mode
- Changing boot order
- Network Settings
- Viewing Network Settings
- Network Settings screen details
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure your system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Redundant OS Control
- Viewing Redundant OS Control
- Redundant OS Control screen details
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Backplane cover
- Inside the system
- Air shroud
- Cooling fans
- Intrusion switch
- Drives
- System memory
- Processors and heat sinks
- Rear drive cage
- Drive backplane
- Expansion cards and expansion card risers
- Optional MicroSD or vFlash card
- Optional IDSDM or vFlash module
- LOM riser card
- Mini PERC card
- Cable routing
- System battery
- Optional internal USB memory key
- Optional optical drive
- Power supply units
- Power interposer board
- Control panel
- System board
- Restore the service tag using Easy Restore
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
Dell EMC PowerEdge R7415 Installation and Service Manual
Installing a drive into the drive carrier
Prerequisites
Follow the safety guidelines listed in Safety instructions.
CAUTION: Mixing drive carriers
from other generations of PowerEdge servers is not supported.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
- Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
- Align the screw holes on the drive with the screws holes on the drive
carrier.When aligned correctly, the back of the drive is flush with the back of the drive carrier.
- Using a Phillips #1 screwdriver, secure the drive to the drive
carrier with screws.
Figure 1. Installing a drive into the drive carrier 
Next steps
- If removed, install the front bezel.
- Install the drive carrier.
请提供评级（1-5星）。
请提供评级（1-5星）。
请提供评级（1-5星）。
请选择这篇文章是否有帮助。
注释中不得包含以下特殊字符：<>()\