- Notes, cautions, and warnings
- Dell EMC PowerEdge R7415 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System BIOS
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- NVMe Settings
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Choosing system boot mode
- Changing boot order
- Network Settings
- Viewing Network Settings
- Network Settings screen details
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure your system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Redundant OS Control
- Viewing Redundant OS Control
- Redundant OS Control screen details
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Backplane cover
- Inside the system
- Air shroud
- Cooling fans
- Intrusion switch
- Drives
- System memory
- Processors and heat sinks
- Rear drive cage
- Drive backplane
- Expansion cards and expansion card risers
- Optional MicroSD or vFlash card
- Optional IDSDM or vFlash module
- LOM riser card
- Mini PERC card
- Cable routing
- System battery
- Optional internal USB memory key
- Optional optical drive
- Power supply units
- Power interposer board
- Control panel
- System board
- Restore the service tag using Easy Restore
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
Dell EMC PowerEdge R7415 Installation and Service Manual
Removing expansion card risers
Prerequisites
- Follow the safety guidelines listed in Safety instructions.
- Follow the procedure listed in Before working inside your system.
- Disconnect any cables connected to the expansion card.
- Remove the air shroud.
- If installed, remove the rear drive cage.
Steps
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.Figure 1. Removing the riser 3A 
- For the riser 1A, first loosen the captive screw and then holding the touch points lift the riser away from the system.
Figure 2. Removing the riser 1A 
- For the riser 1B, follow the steps below:
- Using a Phillips #2 screwdriver, loosen the captive screws.
- Remove the screw at the back of the riser 1B.
- Holding the touch points, lift the riser away from the system.
Figure 3. Removing the riser 1B 
Next steps
请提供评级（1-5星）。
请提供评级（1-5星）。
请提供评级（1-5星）。
请选择这篇文章是否有帮助。
注释中不得包含以下特殊字符：<>()\