How to replace the Memory Module on a Alienware Aurora ACT1250

This 3D experience gives you the step by step process of replacing the Memory Module and a Alienware Aurora ACT1250. The procedure will also include removing the Left Side Cover and reinstalling them.

Removal

Left Side Cover

1. Place the computer in an upright position as shown.
2. Identify the left side cover highlighted in blue.
3. Loosen the captive screw that secures the left side cover release latch to the chassis.
4. Pull the left side cover release latch to release the left side cover from the chassis.
5. At an angle, lift the left side cover from the chassis.
6. Place the computer in horizontal position as shown.

Memory Module

1. Identify the memory module highlighted in blue.
2. Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
3. Remove the memory module from the slot.

Install

Memory Module

1. Identify the memory module location highlighted in blue.
2. Insert the memory module into the slot and press it down until it clicks into place.

Left Side Cover

1. Place the computer in an upright position as shown.
2. Identify the left side cover location highlighted in blue.
3. Align the tabs at the bottom and tilt the left side cover toward the computer until it clicks into place.
4. Tighten the captive screw that secures the left side cover release latch to the chassis.