This 3D experience gives you the step by step process of replacing the Wireless Module (WLAN) and a Alienware M16 R2. The procedure will also include removing the Base Cover, Battery Cable and reinstalling them.
Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover to the system.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the basecover from bottom left and continue on the sides to loosen.
Slide and lift the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 20 seconds to ground the system and remove residual static electricity.
Wireless Module (WLAN)
Install
Wireless Module (WLAN)
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide and align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover to the system.