This 3D experience gives you the step by step process of replacing the SSD (Solid State Drive) 2280 and a G16 7620. The procedure will also include removing the Base Cover, Battery Cable, SSD 2280 and reinstalling them.
Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the basecover from the left corner to loosen.
Lift the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Peel the tape that secure the battery cable to the battery.
Using the pull tab, disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
SSD 2280
Install
SSD 2280
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Adhere the tape securing the battery cable to the battery.
Base Cover
Identify the base cover location highlighted in blue
Align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover.