Removal
Base Cover
Identify the base cover highlighted in blue.
Remove the screws that secure the base cover to the system.
Loosen the captive screws that secure the base cover.
Using a plastic scribe, pry the base cover from the hinges around the outside to loosen.
Lift the base cover off the system.
Memory Modules
Identify the memory modules highlighted in blue.
Peel back the mylar to access the memory module.
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory Modules
Identify the memory modules location highlighted in blue.
Peel back the mylar to access the memory module.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Base Cover
Identify the base cover location highlighted in blue
Align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover.