Ir al contenido principal
Cerrar sesión

Le damos la bienvenida a Dell

Mi cuenta
  • Realice pedidos rápida y fácilmente.
  • Vea los pedidos y haga el seguimiento del estado del envío.
  • Cree una lista de sus productos y acceda a ella
  • Gestione sus sitios, productos y contactos a nivel de producto de Dell EMC con la administración de empresa.
Iniciar sesión Crear una cuenta Inicio de sesión en Premier Iniciar sesión en el programa para socios
Contáctenos

Sus carritos de Dell.com

Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

PDF

Create Host Port

Description

This command creates a new HBA host port identification. The identification is a software value that represents the physical HBA host port to the RAID controller module. Without the host port identification, the RAID controller module cannot receive instructions or data from the host port.

Syntax

create hostPort identifier="
                                 wwid" 
                                 userLabel="
                                 portLabel" 
                                 host="
                                 hostName"
                                 interfaceType=SAS

Parameters

Parameter Description
identifier WWID of the HBA host port. You must put quotation marks (" ") around the WWID.
userLabel Name to give the new HBA host port. You must put quotation marks (" ") around the port label.
host Name of the host for which you are defining an HBA host port. You must put quotation marks (" ") around the host name.
  • NOTE: An HBA host port is a physical connection on a host adapter that resides within a host system. An HBA host port provides host access to the virtual disks in a storage array. If the host bus adapter has only one physical connection (one host port), the terms host port and host bus adapter are synonymous.
interfaceType The identifier for the type of interface for the host port.

You must enter SAS. If you do not enter SAS, the command attempts to use an invalid type of interface. A SAS selection requires an 8-byte WWID.

  • NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.

Valore este contenido

Acertado
Útil
Fácil de entender
¿Le ha resultado útil este artículo?
0/3000 characters
  Proporcione valoraciones (1-5 estrellas).
  Proporcione valoraciones (1-5 estrellas).
  Proporcione valoraciones (1-5 estrellas).
  Seleccione si el artículo le ha resultado útil o no.
  Los comentarios no pueden contener caracteres especiales: <>()\