Ir al contenido principal
Cerrar sesión

Le damos la bienvenida a Dell

Mi cuenta
  • Realice pedidos rápida y fácilmente.
  • Vea los pedidos y haga el seguimiento del estado del envío.
  • Cree una lista de sus productos y acceda a ella
  • Gestione sus sitios, productos y contactos a nivel de producto de Dell EMC con la administración de empresa.
Iniciar sesión Crear una cuenta Inicio de sesión en Premier Iniciar sesión en el programa para socios
Contáctenos

Sus carritos de Dell.com

Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

PDF

Increase Virtual Disk Capacity On A Disk Pool

Description

This command defines the properties for a virtual disk. You can use most parameters to define properties for one or more virtual disks. You also can use some parameters to define properties for only one virtual disk. The syntax definitions are separated to show which parameters apply to several virtual disks and which apply to only one virtual disk. The syntax for virtual disk mapping is listed separately.
  • NOTE: In configurations where disk groups consist of more than 32 virtual disks, the operation can result in host I/O errors or internal RAID controller module reboots due to the expiration of the timeout period before the operation completes. If you experience host I/O errors or internal RAID controller module reboots, bring the host to a quiescent state I/O and try the operation again.

Syntax Applicable To One Or More Virtual Disks

start increaseVolCapacity virtualDisk = 
                                 virtualDiskName incrementalCapacity = 
                                 incrementalCapacity [addDrives = (drive-spec-list)]

Parameter

Parameter Description
addPhysicalDisks The setting to add new physical disks to the virtual disk. For dense expansion enclosures, specify the enclosure ID value, the drawer ID value, and the slot ID value for the physical disk. For non-dense expansion enclosures, specify the enclosure ID value and the slot ID value for the physical disk. Enclosure ID values are 0 to 99. Drawer ID values are 0 to 4. Slot ID values are 0 to 31. Enclose the enclosure ID value, drawer ID value, and the slot ID value in parentheses. Use this parameter with the addCapacity parameter if you need to specify additional physical disks to accommodate the new size.

Each disk pool must be created from a minimum of 11 physical disks specified. There is no upward limit of physical disks supported in a single disk pool, but the number cannot exceed the number of physical disks supported on the storage array.

Valore este contenido

Acertado
Útil
Fácil de entender
¿Le ha resultado útil este artículo?
0/3000 characters
  Proporcione valoraciones (1-5 estrellas).
  Proporcione valoraciones (1-5 estrellas).
  Proporcione valoraciones (1-5 estrellas).
  Seleccione si el artículo le ha resultado útil o no.
  Los comentarios no pueden contener caracteres especiales: <>()\