Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

PDF

Remove Incomplete Remote Replicated Pair From Remote Replication Group

Description

This command removes an orphaned replicated pair virtual disk on the storage array. An orphaned replicated pair virtual disk exists when a member virtual disk in a remote replication group has been removed on one side of the remote replication group (either the primary side or secondary side) but not on the other side.

Orphan replicated pair virtual disks are detected when inter-RAID controller module communication is restored and the two sides of the replication configuration reconcile replication parameters.

Use this command when the replicate relationship is successfully removed on the local or remote storage array, but cannot be removed on the corresponding storage array because of a communication problem.

Syntax

remove asyncRemoteReplicationGroup ["
                                 asyncRemoteReplicationGroupName"]
                                 incompleteReplication virtualDisk="
                                 virtualDiskName"

Parameters

Parameter	Description
`asyncRemoteReplicationGroup`	The name of the remote replication group that contains the orphaned virtual disk that you want to remove. Enclose the remote replication group name in double quotation marks (" "). If the remote replication group name has special characters, you also must enclose the remote replication group name in double quotation marks (" ") inside square brackets.
`incompleteAsyncRemoteReplication`	The name of the orphaned virtual disk that you want to remove from the remote replication group. Enclose the virtual disk name in double quotation marks (" ").