Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.1 User’s Guide

PDF

Configuring CMC SSO Or Smart Card Login For Active Directory Users Using Web Interface

To configure Active Directory SSO or smart card login for CMC:
  • NOTE: For information about the options, see the CMC Online Help.
  1. While configuring Active Directory to setup a user account, perform the following additional steps:
    • Upload the keytab file.
    • To enable SSO, select Enable Single Sign-On option.
    • To enable smart card login, select Enable Smart-Card Login option.
      • NOTE: All command line out-of-band interfaces including secure shell (SSH), Telnet, Serial, and remote RACADM remain unchanged if this option is selected.
  2. Click Apply. The settings are saved.
    You can test the Active Directory using Kerberos authentication using the RACADM command:
    testfeature -f adkrb -u <user>@<domain>
    where <user> is a valid Active Directory user account.

    A command success indicates that CMC is able to acquire Kerberos credentials and access the user's Active Directory account. If the command is not successful, resolve the error and run the command again. For more information, see RACADM Chassis Management Controller for Dell PowerEdge M1000e RACADM Command Line Reference Guide on dell.com/support/manuals.


Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\