Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.1 User’s Guide

Enabling the CMC Network Interface

To enable/disable the CMC Network Interface for both IPv4 and IPv6, type:

racadm config -g cfgLanNetworking -o cfgNicEnable 1
                                 racadm config -g cfgLanNetworking -o cfgNicEnable 0

NOTE: If you disable CMC network interface, the disable operation performs the following actions:
- Disables the network interface access to out-of-band chassis management, including iDRAC and IOM management.
- Prevents the down link status detection.
- To disable only CMC network access, disable both CMC IPv4 and CMC IPv6.

NOTE: The CMC NIC is enabled by default.

To enable/disable the CMC IPv4 addressing, type:

racadm config -g cfgLanNetworking -o cfgNicIPv4Enable
                                    1
                                    racadm config -g cfgLanNetworking -o cfgNicIPv4Enable
                                    0

NOTE: The CMC IPv4 addressing is enabled by default.

To enable/disable the CMC IPv6 addressing, type:

racadm config -g cfgIpv6LanNetworking -o cfgIPv6Enable
                                    1
                                    racadm config -g cfgIpv6LanNetworking -o cfgIPv6Enable
                                    0

NOTE: The CMC IPv6 addressing is disabled by default.

By default, for IPv4, the CMC requests and obtains a CMC IP address from the Dynamic Host Configuration Protocol (DHCP) server automatically. You can disable the DHCP feature and specify static CMC IP address, gateway, and subnet mask.

For an IPv4 network, to disable DHCP and specify static CMC IP address, gateway, and subnet mask, type:

racadm config -g cfgLanNetworking -o cfgNicUseDHCP 0
                                    racadm config -g cfgLanNetworking -o cfgNicIpAddress <static IP address>
                                    racadm config -g cfgLanNetworking -o cfgNicGateway <static gateway>
                                    racadm config -g cfgLanNetworking -o cfgNicNetmask <static subnet mask>

By default, for IPv6, the CMC requests and obtains a CMC IP address from the IPv6 Autoconfiguration mechanism automatically.

For an IPv6 network, to disable the Autoconfiguration feature and specify a static CMC IPv6 address, gateway, and prefix length, type:

racadm config -g cfgIPv6LanNetworking -o
                                    cfgIPv6AutoConfig 0
                                    racadm config -g cfgIPv6LanNetworking -o
                                    cfgIPv6Address <IPv6 address>
                                    racadm config -g cfgIPv6LanNetworking -o
                                    cfgIPv6PrefixLength 64
                                    racadm config -g cfgIPv6LanNetworking -o
                                    cfgIPv6Gateway <IPv6 address>

Bienvenue

Bienvenue dans l’univers Dell

Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.1 User’s Guide

Enabling the CMC Network Interface

Évaluez ce contenu