Dell OpenManage Deployment Toolkit Version 4.3 Command Line Interface Reference Guide

PDF

SYSCFG For IPv6 Configuration

The following table lists all valid options and arguments for IPv6 configuration along with a description of each option. These options are applicable only if the DRAC on your system supports IPv6.

NOTE: On PowerEdge 12G and later systems, this option is available only with the appropriate installed license.

Table 1. SYSCFG Options and Arguments for IPv6 Configuration
Option	Sub-option	Valid Arguments	Description
`lancfgparamsv6 or lcpv6`	`--ipv6`	`enable, disable`	Enables or disables the IPv6 stack. A:> syscfg lcpv6 --ipv6=enable
	`--ipsrcv6=static` `--ipaddrv6= < ipv6address>` `--prefixlengthv6=< prefix lengthv6>` `--gatewayv6=< ipv6gateway address >`	NA	Allows you to manually configure IPv6 addresses. A:>syscfg lcpv6 --ipsrcv6=static --ipaddrv6=1234:1234:1234::1234 --prefixlengthv6=32 --gatewayv6=1234:1234:1234::1
	`--ipsrcv6=auto`	NA	Automatically configures the IPv6 addresses. A:>syscfg lcpv6 --ipsrcv6=auto
	`--dnssrcv6=auto`	NA	Automatically configures the DNS address. A:>syscfg lcpv6 --dnssrcv6=auto
	`--dnssrcv6=static` `--dnsserver1v6=< ipv6dnsserver1address>`	NA	Allows you to manually set the DNS address.
	`--linklocaladdripv6=< linklocaladdripv6>`		Allows you to view IPv6 addresses. A:>syscfg lcpv6 --linklocaladdripv6=134.56.45.233
	`--gatewayv6=< gatewayv6>`		Allows you to view IP gatewayv6 address.