Preskočiť na hlavný obsah
Odhlásiť sa

Vitajte v spoločnosti Dell!

Moje konto
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.
Prihlásiť sa Vytvoriť konto Prihlásenie na stránky Premier Prihlásenie do partnerského programu
Kontaktujte nás

Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual

PDF

Removing the control panel

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified service technicians.
NOTE: You must remove the control panel to replace a faulty control panel.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Remove the three screws that secure the cable tube to the side of the system and remove the cable tube.
  2. Remove the two screws that secure the control panel to the system.
    Figure 1. Removing and installing the cable tube
    This figure shows removing and installing the cable tube.
    1. control panel
    2. screw (5)
    3. cable tube
    4. control panel cable
  3. Remove the screw that secures the control panel cover to the control panel.
  4. Release the ZIF connector latch.
  5. Using the pull-tab, remove the control panel cable from the control panel.
    NOTE: To prevent damage to the control panel cable, exercise utmost care when removing the control panel cable from the control panel.
  6. Remove the control panel from the system.
    Figure 2. Removing and installing the control panel
    This figure shows removing and installing the control panel.
    1. ZIF connector latch
    2. connector
    3. control panel cover
    4. screw

Next steps

Install the control panel.

Ohodnotiť tento obsah

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
0/3000 characters
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, či vám článok pomohol alebo nie.
  Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\