Hi,

last week i received a new PS4100 that was on an older firmware level than my existing group, so i had to install it into it's own group first to be able to upgrade the firmware. So i connected everything, even a serial cable to CM0 and left the datacenter. Remotely i did initial setup and eventually updated the firmware.

Than i could issue a reset command so i could do the initial setup and join it to the existing group.

BUT: after the reset, apparantly it booted into CM1 so now i can't perform any magic to it. If i log into CM0 it says it is not the active controller and i can't perfom any commands.

So how should i have done this? and how can i setup the machine. (please don't tell me to go to the datacenter to switch the console cable... I would think of that as a rather stupid approach!)