Prerequisites
Follow the safety guidelines listed in Safety instructions.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
Remove the air shroud:
Hold the air shroud at both ends and lift it away from the system.
Removing the integrated storage controller card:
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system board.
Lift the integrated storage controller cable to disconnect it from the connector on the system board.
Lift one end of the card and angle it to disengage the card from the card holder on the system board.
Lift the card out of the system.
Installing the integrated storage controller card:
Angle the integrated storage controller card and align the end of the card with the controller card connector on the system board.
Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on the system board.
NOTE:Ensure that the slots on the system board align with the screw holes on the integrated storage controller card connector.
Route the integrated storage controller card cable along the wall of the system.
Align the screws on the integrated storage controller card cable with the screw holes on the connector.
Using Phillips #2 screwdriver, tighten the screws to secure the integrated storage controller card cable to the card connector on the system board.
Install the air shroud:
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
