PowerConnect,7000,v5.0.0.4,A11

Fixes and Enhancement:

Fixes
- OpenManage UI does not accept blank space character for port description.
- "show spanning-tree detail" counters are non-zero for inactive interfaces.
- Unable to remove 0.0.0.0 as default gateway on OOB interface using the web.
- When connecting via SSH, the user is not prompted to acknowledge the MOTD
- "encapsulation" command is unavailable in interface range mode
- M8024-k OpenManage Web UI stack view display
- "spanning-tree transmit hold-count" command's value is not reflected in show command
- Inconsistent behavior in single and range interface mode of "spanning-tree port
- CLI command "no passwords strength exclude-keyword" requires
- Inline help for "spanning-tree loopguard" is incorrect.
- Some of the options of "show ip pim" command are not available in user EXEC mode.
- Configuration command "logging " accepts more than 63 characters.
- dot1dTpPortMaxInfo is displaying maximum frame size that includes MAC header.
- If a user attempts to create a certificate request with information that is not identical to the key generated, the user is not given an error/ informative response letting them know there is a conflict between their key and their request.
- OIDagentInventorySupportedUnitExpected CodeVer provides incorrect display string 1.0.176.0
- 1. Changes are not applied to the correct interfaces on the pages "System->sFlow->Sampler Configuration" "System->sFlow->Poll Configuration" 2. Incorrect error message is displayed when not configured Receiver index is applied to interface on "System->sFlow->Poll Configuration" page.
- "show ip route configured ...longer-prefixes" reports that default gateway is not configured, which is incorrect.
- CLI command "show ip route 192.168.2.2 /24" not ignoring host bits.
- "ipv6 pim join-prune interval" command does not work
- Macro input string does not accept more than 20 characters
- startup-config failed error message is displayed when finishing the Dell Easy Setup Wizard
- In stacking environment, "show system temperature" command output is corrupted
- Error message for port enable / disable on IE on 8024F combo ports
- Alignment issues in the output of "show voice vlan interface" command
- CLI command "show ip igmp snooping" output is truncated.
- vrrp ip command accepts invalid IP addresses
- CLI command "isdp enable" does not work for a range of ports
- "show interface Priority-Flow-Control" command output is not formatted correctly
- CLI command "show ip route 192.168.2.2 /24" not ignoring host bits.
- Port channel goes down during master failover.
- switches rebooting - possible crash dump w/ emWeb
- general mode vlan does not show up after a reload, it shows up in access vlan
- SNMP OIDs 1.3.6.1.4.1.674.10895.3000.1.2.110.7.x causing switch crash
- Stack ARP Problem
- Stack member units port display is missing in web GUI.
- No response to ICMP with jumbo (ping)
- Ports connected to Intel X520 NIC do not return online after reboot.
- switch reboots randomly.

Enhancements
- 802.1Qaz (ETS) on 8100 series
- Added Native EEE Support for the PC8100 10GBaseT Ports
- Support for 40 Gig (QSFP+) interfaces
- Support for Bootcode upgrade from pre-4.x image to 5.x image without manual system reset.
- Local Preference for LAG
- Full Private VLAN
- CLI output filtering
- Routing Improvements for OSPF
- UDLD
- Administrative Profiles
- AAA Authorization
- TACACS+ Accounting
- Stacking over QSFP+ ports
- QSFP+ diagnostics
- sFlow Support on Port Channels