Data Protection Advisor: Agent fails to register with "HTTP response code is 403" error
Summary: Data Protection Advisor agent on Windows fails to register with the application server due to error HTTP response code is 403
Αυτό το άρθρο ισχύει για
Αυτό το άρθρο δεν ισχύει για
Αυτό το άρθρο δεν συνδέεται με κάποιο συγκεκριμένο προϊόν.
Δεν προσδιορίζονται όλες οι εκδόσεις προϊόντων σε αυτό το άρθρο.
Symptoms
The agent fails to register with the DPA application server even after confirming correct agent password. Put the agent into Debug Low by modifying the config file.
- Stop the agent.
- Make a copy of the dpaagent_config.xml
(<install dir>\emc\dpa\agent\etc\dpaagent_config.xml)
- Edit dpaagent_config.xml and set the Logging Level from "Info" to "Debug Low":
<LOGLEVEL>Debug Low</LOGLEVEL>
- Save the file.
- Start the agent.
The following is observed in the agent log:
DBG2 6836.7608 20210310:140114 agent.config - registerAgentProcess(): HTTP response code is 403
ERR 6836.7608 20210310:140114 agent.config - registerAgentProcess(): No response data
ERR 6836.7608 20210310:140114 agent.config - initAgentConfig(): Failed to register agent
ERR 6836.7608 20210310:140114 agent.config - registerAgentProcess(): No response data
ERR 6836.7608 20210310:140114 agent.config - initAgentConfig(): Failed to register agent
Cause
The HTTP 403 Forbidden client error status response code indicates that the server understood the request but refuses to authorize it.
There is an Internet proxy configured in the Windows OS.
On the host, run the following command to confirm if a proxy is configured:
c:\> netsh winhttp show proxy
Current WinHTTP proxy settings:
Proxy Server(s) : proxy.customerdomain.com:8080
There is an Internet proxy configured in the Windows OS.
On the host, run the following command to confirm if a proxy is configured:
c:\> netsh winhttp show proxy
Current WinHTTP proxy settings:
Proxy Server(s) : proxy.customerdomain.com:8080
Resolution
- Remove the proxy configuration:
c:\> netsh winhttp reset proxy
- Restart the DPA agent.
- Confirm the agent has registered by checking the dpaagent.log:
INFO 6836.7608 20210310:150114 agent.config - initAgentConfig(): Agent has successfully registered with the server
It should now be visible on the GUI under Data Collection > Agents.
Remember to set the agent logging level back to Info.
Contact Dell Technical Support for further information.
Επηρεαζόμενα προϊόντα
Data Protection, Data Protection Suite, Data Protection AdvisorΙδιότητες άρθρου
Article Number: 000184051
Article Type: Solution
Τελευταία τροποποίηση: 10 Σεπ 2025
Version: 5
Βρείτε απαντήσεις στις ερωτήσεις σας από άλλους χρήστες της Dell
Υπηρεσίες υποστήριξης
Ελέγξτε αν η συσκευή σας καλύπτεται από τις Υπηρεσίες υποστήριξης.