Dell Data Protection Encryption endpoint with SED showing as Not Protected in Remote Management Console
概要: Learn more about Dell Enterprise Server Remote Management Console showing an endpoint's EndPoint Protection Status as Not Protected when the Dell Data Protection | Encryption client is installed with a Self-Encrypting Drive (SED) and has System Data Encryption (SDE) policy enabled. ...
この記事は次に適用されます：
この記事は次には適用されません：
この記事は、特定の製品に関連付けられていません。
すべての製品パージョンがこの記事に記載されているわけではありません。
現象
Affected Products:
- Dell Data Protection | Self-Encrypting Drive
原因
This is because the Dell Data Protection | Encryption client is designed to disable SDE if it detects a SED drive. When the Dell Data Protection | Enterprise Server has SDE set as a policy for this machine, the device sweep timestamp is not updated, and the server does not set the Protected flag.
解決方法
In the Remote Management Console, all other status fields for this endpoint have the correct information, but the SDE start and end sweep time fields are blank.
You can search for CanApplySDE on any device with the Dell Data Protection | Encryption software client to determine if an SED or Full Volume Encryption (FVE) policy is in play and being applied.
When the Shield can apply the SDE policy properly, you see this line:
CanApplySDE? - Yes (SED present = 0, FVE Provisioned = 0, FVE Decrypting = 0, Always Apply= 0, FVE Disks=0)
Note: For information about activating the SDE policy if SED is detected, reference How to enable SDE policies on Self-Encrypting Drives.
To contact support, reference Dell Data Security International Support Phone Numbers.
Go to TechDirect to generate a technical support request online.
For additional insights and resources, join the Dell Security Community Forum.
対象製品
Dell Encryption文書のプロパティ
文書番号: 000129499
文書の種類: Solution
最終更新: 29 6月 2026
バージョン: 10
質問に対する他のDellユーザーからの回答を見つける
サポート サービス
お使いのデバイスがサポート サービスの対象かどうかを確認してください。