Dell Precision and OptiPlex Optional Module Information

No symptom information is available.

No cause information is available.

Optional Port Module Card

Some Dell Precision and OptiPlex systems have the possibility of installing an optional port module card. This could be for an additional VGA, HDMI, USB-C, DVI, Serial Port, and so forth. This is because the systems do not have these ports available on the system board.

Check the Service Manual for your system model to verify if this option is available:

• Dell OptiPlex
• Dell Precision

Installing and Removing the Module Card

The following steps are an example of how to install or remove the module card.

Installing the Module Card:

1. To remove the metal bracket, insert a flat-head screwdriver in the hole of bracket [1], push the bracket to release the bracket [2], and lift the bracket out from the system.
   
2. Insert the VGA module into its slot from the inside of your computer [1]. Connect the VGA cable to the connector on the system board [2].
   
3. Replace the two (M3X3) screws to secure the optional VGA module to the system.
   

Removing the Module Card:

1. Remove the two (M3X3) screws that secure the optional VGA module to the system.
   
2. Disconnect the VGA cable from the connector on the system board [1]. Remove the VGA module from the system [2].
   

For information about purchasing these cards, contact Dell Sales Support.

Back to Top