Gå vidare till huvudinnehållet
  • Lägg beställningar snabbt och enkelt
  • Visa beställningar och kontrollera leveransstatus
  • Skapa och kom åt en lista över dina produkter

Setting a Static IP Address on your Dell Laser Printer using the Embedded Web Server (EWS)

Sammanfattning: Use Embedded Web Server (EWS) to set static IP address on Dell printer.

Den här artikeln gäller för Den här artikeln gäller inte för Den här artikeln är inte kopplad till någon specifik produkt. Alla produktversioner identifieras inte i den här artikeln.

Symptom

No symptoms information is available.

Orsak

No cause information is available.

Upplösning

Setting a Static IP Address on your Dell Laser Printer using the Embedded Web Server (EWS)

The Embedded Web Server (EWS) is an online web page which allows you to make changes to your Printer's Operating Panel using the network connection.

Use the guide below to set a Static IP Address on your Dell Laser Printer. The guide below uses the Dell 5130cn Laser Printer as an example, other printers may vary slightly.

  1. Print a settings page from your printer to obtain the IP address assigned to it (this may change depending on your system type, see your User Guide for information about Printing a Printer/System Settings Page).
  2. The IP Address is listed under 'Network' subheading (Figure 1 [English only]).

    Network IP Address on settings page
    Figure 1: Network IP Address on settings page
  3. Enter the Printers IP Address into a Web Browser and Enter.
  4. The EWS should now be open (Figure 2 [English only]).

    EWS
    Figure 2: EWS
  5. Click on Print Server Settings (Figure 3 [English only]).

    Click Printer Server Settings
    Figure 3: Click Printer Server Settings
  6. Click on the Print Server Settings Tab (Figure 4 [English only]).

    Printer Server Settings Tab
    Figure 4: Printer Server Settings Tab
  7. Click on the TCP/IP Tab (Figure 5 [English only]).

    Click TCP/IP
    Figure 5: Click TCP/IP
  8. In the TCP/IP Settings, use the dropdown menu to select IP Address Mode as Manually Set (Figure 6 [English only]).

    IP Address Mode drop down
    Figure 6: IP Address Mode drop down
  9. Input the Manual IP Address, the Manual Subnet Mask, and the Manual Default Gateway (Figure 7 [English only]).
    Note: In order to find your Subnet Mask and Default Gateway, use the IP Config Command as explained in the article below.

    Top commands for use in Command Prompt

    Manual input IP, Subnet Mask, and Default Gateway
    Figure 7: Manual input IP, Subnet Mask, and Default Gateway
  10. Scroll down and click on Apply New Settings (Figure 8 [English only]).

    Apply New Settings
    Figure 8: Apply New Settings
  11. The Printer should restart, and the settings should now be saved and the Printer should now have the IP Address you have set.
  12. Print another System Settings Page to ensure the setting has been saved correctly.

If these steps do not correct the problem, contact Dell Technical Support.

Back to Top

Produkter

Printers & Accessories, Dell Printers, MultiFunction Printers, Legacy Printers, Smart Printers
Artikelegenskaper
Artikelnummer: 000135385
Artikeltyp: Solution
Senast ändrad: 07 apr. 2023
Version:  4
Få svar på dina frågor från andra Dell-användare
Supporttjänster
Kontrollera om din enhet omfattas av supporttjänster.