Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

iDRAC 8/7 v2.30.30.30 User’s Guide

PDF

Creating virtual disks using web interface

To create virtual disk:
  1. In the iDRAC Web interface, go to Overview > Storage > Virtual Disks > Create . The Create Virtual Disk page is displayed.
  2. In the Settings section, do the following:
    1. Enter the name for the virtual disk.
    2. From the Controller drop-down menu, select the controller for which you want to create the virtual disk.
    3. From the Layout drop-down menu, select the RAID level for the Virtual Disk. Only those RAID levels supported by the controller appear in the drop-down menu and it is based on the RAID levels are available based on the total number of physical disks available.
    4. Select the Media Type, Stripe Size, Read Policy, Write Policy, Disk Cache Policy, T10 PI Capability. Only those values supported by the controller appear in the drop-down menus for these properties.
    5. In the Capacity field, enter the size of the virtual disk. The maximum size is displayed and then updated as disks are selected.
    6. The Span Count field is displayed based on the selected physical disks (step 3). You cannot set this value. It is automatically calculated after selecting disks for multi-raid level. If you have selected RAID 10 and if the controller supports uneven RAID 10, then the span count value is not displayed. The controller automatically sets the appropriate value.
  3. In the Select Physical Disks section, select the number of physical disks. For more information about the fields, see the iDRAC Online Help
  4. From the Apply Operation Mode drop-down menu, select when you want to apply the settings.
  5. Click Create Virtual Disk. Based on the selected Apply Operation Mode, the settings are applied.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\