Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

iDRAC 8/7 v2.30.30.30 User’s Guide

PDF

Generating SupportAssist Collection manually

When iSM is not installed, you can manually run the OS collector tool to generate the SupportAssist collection. You must run OS Collector tool on the server OS to export the OS and application data. A virtual USB device labeled DRACRW appears in the server operating system. This device contains the OS Collector file that is specific for the host operating system. Run the file specific for the operating system from the server OS to collect and transfer the data to iDRAC. You can then export the data to a local or network shared location.

In Dell’s 13th generation of PowerEdge servers, the OS collector DUP is installed in factory. However, if you determine that OS Collector is not present in iDRAC, then you can download the DUP file from the Dell support site and then upload the file to iDRAC using the Firmware Update process.

Before you manually generate the SupportAssist collection using the OS collector tool, do the following on the host operating system:
  • On Linux operating system: Check if the IPMI service is running. If it is not running, you must manually start the service. The following table provides the commands that you can use to check the IPMI service status and start the service (if required) for each Linux OS.
    Linux Operating System Command to Check the IPMI Service Status Command to Start the IPMI Service

    Red Hat Enterprise Linux 5 64-bit

    Red Hat Enterprise Linux 6

    SUSE Linux Enterprise Server 11

    CentOS 6

    Oracle VM

    Oracle Linux 6.4

    		 
    $ service ipmi status
    		 
    $ service ipmi start
    Red Hat Enterprise Linux 7 
    $ systemctl status ipmi.service
    		 
    $ systemctl start ipmi.service
    • NOTE:
      • CentOS is supported only for iDRAC Service Module 2.0 or later.
      • If the IPMI modules are not present, then you can install the respective modules from the OS distribution media. The service starts once the installation is complete.
  • On Windows operating system:
    • Check if the WMI service is running:
      • If WMI is stopped, OS Collector starts the WMI automatically and continues with the collection.
      • If WMI is disabled, OS Collector collection stops with an error message.
    • Check the appropriate privilege levels and make sure there is no Firewall or security settings that is preventing to get the registry or software data.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\