Gå til hovedindhold

Dell Chassis Management Controller Version 3.10 for Dell EMC PowerEdge VRTX User's Guide

PDF

Command Messages

The following table lists the RACADM commands and output for common FlexAddress situations.

Table 1. FlexAddress Commands and Output . The following table lists the racadm commands and output for FlexAddress.
Situation	Command	Output
SD card in the active CMC module is bound to another service tag.	`$racadm featurecard -s`	`The feature card inserted is valid and contains the following feature(s)` `FlexAddress: bound to another chassis, svctag = <Service tag Number> SD card SN = <Valid flex address serial number>`
SD card in the active CMC module that is bound to the same service tag.	`$racadm featurecard -s`	`The feature card inserted is valid and contains the following feature(s)` `FlexAddress: bound`
SD card in the active CMC module that is not bound to any service tag.	`$racadm featurecard -s`	`The feature card inserted is valid and contains the following feature(s)` `FlexAddress:not bound`
FlexAddress feature not active on the chassis for any reason (No SD card inserted/ corrupt SD card/ after feature deactivated /SD card bound to a different chassis).	`$racadm setflexaddr [-f <fabricName> <slotState>]` `$racadm setflexaddr [-i <slot#> <slotstate>]`	`ERROR: Flexaddress feature is not active on the chassis`
Guest user attempts to set FlexAddress on slots/fabrics.	`$racadm setflexaddr [-f <fabricName> <slotState>]` `$racadm setflexaddr [-i <slot#> <slotstate>]`	`ERROR: Insufficient user privileges to perform operation`
Deactivating FlexAddress feature with chassis powered ON.	`$racadm feature -d -c flexaddress`	`ERROR: Unable to deactivate the feature because the chassis is powered ON`
Guest user tries to deactivate the feature on the chassis.	`$racadm feature -d -c flexaddress`	`ERROR: Insufficient user privileges to perform operation`
Changing the slot/fabric FlexAddress settings while the server modules are powered ON.	`$racadm setflexaddr -i 1 1`	`ERROR: Unable to perform the set operation because it affects a powered ON server`
Changing the Flexaddress settings of slot or fabric, when the CMC Enterprise License is not installed.	`$racadm setflexaddr -i<slotnum> <status>` $racadm setflexaddr -f<FabricName> <status>	`ERROR: SWC0242 : A required license is missing or expired. Obtain an appropriate license and try again, or contact your service provider for additional details.` NOTE: To resolve this issue, you must have a FlexAddress Enablement license.