Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell Chassis Management Controller Version 3.10 for Dell EMC PowerEdge VRTX User's Guide

PDF

Configuring Active Directory With Extended Schema Using RACADM

To configure a CMC Active Directory with Extended Schema by using the RACADM commands, oen a command prompt and enter the following commands at the command prompt: 
racadm config -g cfgActiveDirectory -o cfgADEnable 1
                                 racadm config -g cfgActiveDirectory -o cfgADType 1
                                 racadm config -g cfgActiveDirectory -o cfgADRacName <RAC common name>
                                 racadm config -g cfgActiveDirectory -o cfgADRacDomain < fully qualified rac domain name >
                                 racadm config -g cfgActiveDirectory -o cfgADDomainController1 < fully qualified domain name or IP Address of the domain controller
                                 >
                                 racadm config -g cfgActiveDirectory -o cfgADDomainController2 < fully qualified domain name or IP Address of the domain controller
                                 >
                                 racadm config -g cfgActiveDirectory -o cfgADDomainController3 < fully qualified domain name or IP Address of the domain controller
                                 >
  • NOTE: You must configure at least one of the three addresses. CMC attempts to connect to each of the configured addresses one-by-one until it makes a successful connection. With Extended Schema, these are the FQDN or IP addresses of the domain controllers where this CMC device is located.
To disable the certificate validation during an handshake (optional): 
racadm config -g cfgActiveDirectory -o cfgADCertValidationEnable 0
  • NOTE: In this case, you do not have to upload a CA certificate.
To enforce the certificate validation during SSL handshake (optional): 
racadm config -g cfgActiveDirectory -o cfgADCertValidationEnable 1
In this case, you must upload a CA certificate: 
racadm sslcertupload -t 0x2 -f < ADS root CA certificate >
  • NOTE: If certificate validation is enabled, specify the Domain Controller Server addresses and the FQDN. Make sure that DNS is configured correctly under.
Using the following RACADM command may be optional: 
racadm sslcertdownload -t 0x1 -f < RAC SSL certificate >

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\