Dell EMC Networking OS Configuration Guide for the S5048F–ON System 9.14.2.4

DSCP

0 – 5, 10 - 15  20 – 25, 30 – 35

Expected PFC Priority

1      2

To configure the aforementioned DSCP and PFC priority values, perform the following tasks:

1. Create class-maps to group the DSCP subsets

   class-map match-any dscp-pfc-1
    match ip dscp 0-5,10-15
   !
   class-map match-any dscp-pfc-2
    match ip dscp 20-25,30-35

2. Associate above class-maps to Queues Queue assignment as below.

   Table 1. Queue AssignmentsQueue Assignments

   Internal-priority	Queue
   0	0
   1	0
   2	0
   3	1
   4	2
   5	3
   6	3
   7	3

   DellEMC(conf)#do show qos dot1p-queue-mapping
   Dot1p Priority : 0  1  2  3  4  5  6  7
            Queue : 1  0  2  3  4  5  6  7

3. Dot1p->Queue Mapping Configuration is retained at the default value.

4. Interface Configurations on server connected ports.

   1. Enable DCB globally.

      DellEMC(conf)#dcb enable

   2. Apply PFC Priority configuration. Configure priorities on which PFC is enabled.

      DellEMC(conf-if-tf-1/1)#pfc priority 1,2