Dell EMC Networking OS Configuration Guide for the S5048F–ON System 9.14.2.4

Important Points to Remember

• When you restore all the units in a stack, these units are placed in standalone mode.

• When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.

• When you restore the units in standalone mode, the units remain in standalone mode after the restoration.

• After the restore is complete, the units power cycle immediately.

The following example illustrates the restore factory-defaults command to restore the factory default settings.

DellEMC#restore factory-defaults stack-unit 1 nvram

    ***********************************************************************
    *  Warning - Restoring factory defaults will delete the existing      *
    *  persistent settings (stacking, fanout, etc.)                       *
    *  After restoration the unit(s) will be powercycled immediately.     *
    *  Proceed with caution !                                             *
    ***********************************************************************

Proceed with factory settings? Confirm [yes/no]:yes

-- Restore status --
Unit   Nvram     Config
------------------------
  1    Success   

Power-cycling the unit(s).
....