Zu den Hauptinhalten

Dell EMC Networking OS Configuration Guide for the S5048F–ON System 9.14.2.4

PDF

Configuring the System to Drop Certain ICMP Reply Messages

You can configure the Dell EMC Networking OS to drop ICMP reply messages. When you configure the drop icmp command, the system drops the ICMP reply messages from the front end and management interfaces. By default, the Dell EMC Networking OS responds to all the ICMP messages.

Drop the ICMP or ICMPv6 message type.

drop {icmp | icmp6}

CONFIGURATION mode.

You can configure the Dell EMC Networking OS to suppress the following ICMPv4 and ICMP6 message types:

Table 1. Suppressed ICMP message typesSuppressed ICMP message types
ICMPv4 message types
Echo reply (0)
All sub types of destination unreachable (3)
Source quench (4)
Redirect (5)
Router advertisement (9)
Router solicitation (10)
Time exceeded (11)
IP header bad (12)
Timestamp request (13)
Timestamp reply (14)
Information request (15)
Information reply (16)
Address mask request (17)
Address mask reply (18)

NOTE The Dell EMC Networking OS does not suppress the ICMP message type echo request (8).

Table 2. Suppressed ICMPv6 message typesSuppressed ICMPv6 message types
ICMPv6 message types
Destination unreachable (1)
Time exceeded (3)
IPv6 header bad (4)
Echo reply (129)
Who are you request (139)
Who are you reply (140)
Mtrace response (200)
Mtrace messages (201)

NOTE The Dell EMC Networking OS does not suppress the following ICMPv6 message types:

Packet too big (2)
Echo request (128)
Multicast listener query (130)
Multicast listener report (131)
Multicast listener done (132)
Router solicitation (133)
Router advertisement (134)
Neighbor solicitation (135)
Neighbor advertisement (136)
Redirect (137)
Router renumbering (138)
MLD v2 listener report (143)
Duplicate Address Request (157)
Duplicate Address Confirmation (158)