Latitude 7490 Owner's Manual

Installing the display hinge cap

1. Place the display hinge cap on the slot and slide it back to fit on the display assembly.
   NOTE The display cable, touch sensor cable (for models shipped with a touchscreen display assembly), and ASA antenna cable (for models shipped with an infinity bezel) must be routed correctly in the routing channels around the left display hinge. Then, using the piece of tape attached to the display cable, secure it to the display back-cover.
2. Install the display assembly.
3. Install the WLAN card.
4. Install the WWAN card.
5. Connect the battery cable to the connector on the system board.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.