Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Changing System Logging Settings

You can change the default settings of the system logging by changing the severity level and the storage location.

The default is to log all messages up to debug level, that is, all system messages. By changing the severity level in the logging commands, you control the number of system messages logged.

To specify the system logging settings, use the following commands.

  • Specify the minimum severity level for logging to the logging buffer. CONFIGURATION mode logging buffered level
  • Specify the minimum severity level for logging to the console. CONFIGURATION mode logging console level
  • Specify the minimum severity level for logging to terminal lines. CONFIGURATION mode logging monitor level
  • Specify the minimum severity level for logging to a syslog server. CONFIGURATION mode logging trap level
  • Specify the minimum severity level for logging to the syslog history table. CONFIGURATION mode logging history level
  • Specify the size of the logging buffer. CONFIGURATION mode logging buffered size
    • NOTE: When you decrease the buffer size, the system deletes all messages stored in the buffer. Increasing the buffer size does not affect messages in the buffer.
  • Specify the number of messages that the system saves to its logging history table. CONFIGURATION mode logging history size size

To view the logging buffer and configuration, use the show logging command in EXEC privilege mode, as shown in the example for Display the Logging Buffer and the Logging Configuration.

To view the logging configuration, use the show running-config logging command in privilege mode, as shown in the example for Configuring a UNIX Logging Facility Level .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\