Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Reassigning an Interface to a New Port Channel

An interface can be a member of only one port channel. If the interface is a member of a port channel, remove it from the first port channel and then add it to the second port channel.

To reassign an interface to a new port channel, use the following commands.

  1. Remove the interface from the first port channel. INTERFACE PORT-CHANNEL mode no channel-member interface
  2. Change to the second port channel INTERFACE mode. INTERFACE PORT-CHANNEL mode interface port-channel id number
  3. Add the interface to the second port channel. INTERFACE PORT-CHANNEL mode channel-member interface

Example of Moving an Interface to a New Port Channel

The following example shows moving the TenGigabitEthernet 1/8 interface from port channel 4 to port channel 3. 
Dell(conf-if-po-1)#show config
                                 !
                                 interface Port-channel 1
                                 no ip address
                                 channel-member TenGigabitEthernet 0/16
                                 shutdown
                                 Dell(conf-if-po-1)#no chann tengig 1/8
                                 Dell(conf-if-po-1)#int port 5
                                 Dell(conf-if-po-5)#channel tengig 1/8
                                 Dell(conf-if-po-5)#show conf
                                 !
                                 interface Port-channel 5
                                 no ip address
                                 channel-member TenGigabitEthernet 1/8
                                 shutdown
                                 Dell(conf-if-po-5)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\