- Notes, cautions, and warnings
- Working on your computer
- Major components of your system
- Technology and components
- Disassembly and reassembly
- System setup
- Troubleshooting
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Power-Supply Unit Built-in Self-Test
- Real-Time Clock (RTC Reset)
- System diagnostic lights
- Diagnostic error messages
- System error messages
- Recovering the operating system
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
Vostro 3681 Service Manual
Installing the media card reader
Prerequisites
About this task
The following images indicate the location of the media card reader and provide a visual representation of the installation procedure.
Steps
- Place the SD card reader on the system board ensuring the SD card reader sits flush on the connector on the system board.
- Replace the two M3x5 screws securing the SD card reader to the system board.
- Route the PSU power cable from over the SD card reader.
Next steps
- Install the HDD/ODD Bracket.
- Install the front bezel.
- Install the side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\